sutton073

I finally built myself a simple but effective lumber rack system. I built it entirely out of 2x4's and it took me probably three hours to complete, not to bad by myself. It is large enough to store 12' long boards, and plenty of them! The way it is designed, the lumber is supposed to be slid in and out on end. This works perfect in my shop because it is shaped like a "L". The lumber rack is right on the top of the bottom, flat part of the "L". It was definitely the best spot for my lumber rack and I will go into more detail of why in a later post. I have drawn a little set of plans on sketchup that better shows how it was put together. I built each unit with pine 2x4's and I nailed them together on the floor with a pneumatic nail gun using some old ring shank nails that I had laying around. You can use screws if you want to take the time but I think the ring shank nails will hold just about as good as a screw would. I spaced the units 16" apart to p...

Just today, I finished building my third set of cornhole boards. The first two sets that I built were for myself and the third set is for a freind who is also addicted to cornhole on Friday and Saturday nights. The boards are made of 5/8" plwood trimmed in 3/4" select pine grade boards with 3/4" oak legs. I used pockethole-joinery to join the pine to the plywood and screws to attach the hinges and the legs. Glue was used on all joints. The first two sets of cornhole boards I made where not as good of quality as these boards are. I used 3/4" plywood and 3/4" pine for the first set but I didn't join the pine to the plywood flush with the top like I did with these boards, that should make the edges of the board more durable and it looks great also. Also I just screwed the top down into the pine framing leaving the screws exposed in the top of the boards. On my first set I used a simular hinge setup for the legs which never gave me any trouble. On the seco...